ONDO STATE EXAM CHEMISTRY ANSWERS » ExamKing.Net The Anthencity of Our Runs Retains Our Status As Best And No1 Exam Answers Suppliers In Nigeria And Africa @ Large
DO YOU WANT TO CONTACT US???
08065582389 || +2348065582389
ONLINE CANDIDATES :
*ONDO STATE JOINT CHEMISTRY ANSWERS*
*ONDO STATE CHEMISTRY*
_Instructions: Answer Questions One (1)and other (3) Three Questions Making 4 Questions in total to be answered by you_
2HCL + Na2CO3 –––> 2Nacl + CO2 + H2O
Final burette Reading (cm³) | Rough 24.00 | First 22.50 | Second 23.00 | Third 23.10
initial Burette Reading (cm³) | Rough 0.00 | First 0.00 | Second 0.00 | Third 0.00 |
Volume of Acid used (cm³) | Rough 24.00 | First 22.50 | Second 23.00 | Third 23.10
*NOTE: ENSURE YOU USE YOUR SCHOOL TITRE VALUE AND VOLUME OF ACID USED*
a=23.00 – 23.00
c=23.10 – 0.00
Average Titre Value = 2nd Titre Value + 3rd Titre Value ÷ 2
= 23.00 + 23.10 ÷ 2
Therefore, Average Titre Value, VA = 23.05cm³
CA=?, CB=?, VA=23.05cm³, VB=25cm³
Mass of A = 3g/dm³
Molar Mass Of A = H + Cl = 1 + 35.5
Molar Mass of A = 36.5g/Mol
Molar Concentration = Mass Concentration ÷ Molar Mass
= 3 ÷ 36.5
:. CA = 0.0822mol/dm³
CAVA/CBVB = nA/nB
Where nA = 2 , nB = 1, CB =?, CA = 0.0822mol/dm³ , VB = 25
===> 0.0822 × 23.05 ÷ CB × 25 = 2/1
CB = 0.0822 × 23.05 ÷ 2 × 25
CB = 1.8947 ÷ 50
CB = 0.0379Mol/dm³
(ii) Separating funnel
(iii) Conical Flask
(i) Beaker:- This is used to hold liquids in the laboratory for liquid
(ii) Separating funnel:- This is used in the laboratory for Liquid Extractions, It is Precisely used to separate a mixture of two solvents of different densities.
(iii) Conical Flask:- This is used for holding And Measuring Chemical Liquid Samples.
(iv) Pipette:- This is used to measure out Or transfer Small Quantities of liquids.
(v) Burette:- This is used during quantitative analysis to measure the volume of a given liquid or gas.
(Pick Any five)
(i) Obey safety Rules
(ii) Dress Properly
(iii) Handle Corrosive chemicals with extreme care
(iv) Do not mix chemical carelessly
(v) Seek the guidance of the lab attendant if you are in doubt of any mixture you want to carry out
(vi) Do not taste or sniff Chemicals
(vii) Identify Safety Equipment
Basicity of an acid is defined as the number of replaceable hydrogen atom of the same acid by a base
(i) Lactic Acid ——> Milk
(ii) Absorbic ——> Orange (Citrus Fruit)
(iii) Amino Acid ——> Meat, Beans, Fish, Eggs (Pick one)
Graham’s law of diffusion states that the rate of diffusion of a gas is inversely proportional to the square root of its vapour density.
Check the diagram
(ii)Dative or Co-ordinate covalent bond.
-(Choose any 3)-
(i)They have high melting point or boiling point.
(ii)They conduct electricity when molten or in solution.
(iii)They exist as aggregates of ions.
(iv)They are soluble in polar solvent e.g water and insoluble in non-polar solvents.
Definition of water pollution. Water pollution is the release or injection of substances into the water bodies in quantities or level that are harmful to man, animals and plants.
(Pick any four)
(i) Domestic waste/sewage/household waste.
(ii) Industrial waste/dyes/detergents/lead/mercury compounds.
(iii) Agricultural wastes/pesticides/insecticides/fertilizers.
(iv) Oil spillage.
(v) Hot water/thermal plants.
(Pick any Five)
(i)Proper legislation on use of water bodies.
(ii) Avoid dumping of untreated wastes into the waters.
(iii) Public enlightenment.
(iv) Good fishing practices.
(v) Providing public utilities e.g. toilets, incinerators, etc.
(vi) Treatment of industrial waste.
(i) Yellow Rhombic Sulphur (α-sulphur).
(ii) Monoclinic Sulphur (β-sulphur).
(i) Rhombic sulphur exists as rhombic octahedral crystals whereas Monoclinic sulphur exists as long, needle-shape prisms.
(ii) Rhombic sulphur the S8 molecules fit tightly into each other, whereas in Monoclinic sulphur, the S8 molecules are piled up on top of each other.
(iii) Rhombic sulphur is stable below 96°C whereas Monoclinic sulphur is stable above 96°C.
(iv) Rhombic sulphur is bright in yellow in colour while; Monoclinic Sulphur is dull yellow in colour.
(v) Rhombic sulphur has low thermal and electrical conductivity while; Monoclinic Sulphur has high thermal and electrical conductivity.
(i) Purification of some metals.
(ii) Electrolysis is used in production of gases, e.g. Hydrogen from water.
(iii) Used in extraction of some metals from their ores, e.g. Aluminium from bauxite.
error: Content is protected !!